Show simple item record

contributor authorTetsuya Yamaki
contributor authorJunichi Tsukada
contributor authorMasaharu Asano
contributor authorRyoichi Katakai
contributor authorMasaru Yoshida
date accessioned2017-05-09T00:24:27Z
date available2017-05-09T00:24:27Z
date copyrightFebruary, 2007
date issued2007
identifier issn2381-6872
identifier otherJFCSAU-28928#56_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/136143
description abstractWe prepared novel ion exchange membranes for possible use in polymer electrolyte fuel cells (PEFCs) by the radiation-induced graft copolymerization of styrene and new crosslinker bis(vinyl phenyl)ethane (BVPE) into crosslinked polytetrafluoroethylene (cPTFE) films and subsequent sulfonation and then investigated their water uptake, proton conductivity, and stability in an oxidizing environment. In contrast to the conventional crosslinker, divinylbenzene (DVB), the degree of grafting of styrene∕BVPE increased in spite of high crosslinker concentrations in the reacting solution (up to 70mol%). Quantitative sulfonation of the aromatic rings in the crosslinked graft chains resulted in the preparation of membranes with a high ion exchange capacity that reached 2.9meq∕g. The bulk properties of the membranes were found to exceed those of Nafion membranes except for chemical stability. The emphasis was on the fact that the BVPE-crosslinked membranes exhibited the higher stability in the H2O2 solution at 60°C compared to the noncrosslinked and DVB-crosslinked ones, as well as decreased water uptake and reasonable proton conductivity. These results are rationalized by considering the reactivity between styrene and the crosslinker, which is an important factor determining the distribution of the crosslinks in the graft component. In the case of BVPE, the crosslinks at a high density were homogeneously incorporated even into the interior of the membrane because of its compatibility with styrene while the far too reactive DVB led to a crosslink formation only near the surface. The combination of both the cPTFE main chain and BVPE-based grafts, i.e., a perfect “double” crosslinking structure, is likely to effectively improve the membrane performances for PEFC applications.
publisherThe American Society of Mechanical Engineers (ASME)
titlePreparation of Highly Stable Ion Exchange Membranes by Radiation-Induced Graft Copolymerization of Styrene and Bis(vinyl phenyl)ethane Into Crosslinked Polytetrafluoroethylene Films
typeJournal Paper
journal volume4
journal issue1
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.2393305
journal fristpage56
journal lastpage64
identifier eissn2381-6910
keywordsMembranes
keywordsRadiation (Physics)
keywordsWater AND Protons
treeJournal of Fuel Cell Science and Technology:;2007:;volume( 004 ):;issue: 001
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record