Show simple item record

contributor authorJ. A. Linnekoski
contributor authorJari Keskinen
contributor authorJ. Lamminen
contributor authorT. Anttila
contributor authorA. O. Krause
date accessioned2017-05-09T00:24:27Z
date available2017-05-09T00:24:27Z
date copyrightFebruary, 2007
date issued2007
identifier issn2381-6872
identifier otherJFCSAU-28928#45_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/136141
description abstractPlatinum and other platinum group metals, either as singles or in combinations, have been preferred for use in low temperature fuel cells, mainly alkaline fuel cells (AFCs), polymer membrane electrolyte fuel cells (PEMs), and direct methanol fuel cells (DMFCs), for hydrogen oxidation reaction (HOR). However, also the Raney-nickel catalyst, which is among the most active non-noble metals for the HOR, has been the target of interest, especially in AFCs. However, electrodes with nonsupport Raney-nickel catalysts have been reported to suffer from insufficient conductivity. So, in this work, in order to enhance the electrical conductivity in the catalyst layer and to increase the catalytic activity, the Raney-nickel catalysts were alloyed with carbon in a planetary-type ball mill. In some samples platinum was added chemically to still enhance the catalytic properties. The activity of the processed materials was tested in the anode reaction of the alkaline fuel cell by measuring the half-cell polarization curves. It was found that the effective mixing of Raney-nickel powder and carbon in the ball mill was beneficial compared with poorer mixing in the knife mill. However, in order to achieve the same current densities at the same polarization level as the commercial Pt catalyst (2mg∕cm2), much higher Raney-nickel contents (73mg∕cm2) were needed. Good contact between Raney-nickel and conductive material (carbon) in the catalyst layer of the alkaline fuel cell electrode can improve the performance of the Raney-nickel catalyst in the hydrogen oxidation reaction. The polarization was lowered especially at the higher current densities (>250mA∕cm2).
publisherThe American Society of Mechanical Engineers (ASME)
titleProcessing of Raney-Nickel Catalysts for Alkaline Fuel Cell Applications
typeJournal Paper
journal volume4
journal issue1
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.2397140
journal fristpage45
journal lastpage48
identifier eissn2381-6910
keywordsNickel
keywordsElectrodes
keywordsCatalysts
keywordsPolarization (Electricity)
keywordsPlatinum
keywordsCarbon AND Hydrogen
treeJournal of Fuel Cell Science and Technology:;2007:;volume( 004 ):;issue: 001
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record