Show simple item record

contributor authorMauro Sgroi
contributor authorGuido Saracco
contributor authorStefania Specchia
contributor authorGianluca Bollito
contributor authorGianfranco Innocenti
contributor authorUgo Andrea Icardi
date accessioned2017-05-09T00:24:25Z
date available2017-05-09T00:24:25Z
date copyrightAugust, 2007
date issued2007
identifier issn2381-6872
identifier otherJFCSAU-28930#345_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/136118
description abstractMicro power sources have a wide potential market for consumer electronics and portable applications, such as weather stations, medical devices, signal units, APU (auxiliary power units), gas sensors, and security cameras. A micro power source could be the direct methanol fuel cell system (DMFC). An important aspect of this system is the precise control of the concentration of the alcohol-water solution fed to the anode. Different detection principles were taken into consideration: electrochemical, infrared spectroscopy, gas chromatography, refractometry, density measurements, ultraviolet absorption. The present work is devoted to the study of an electrochemical amperometric sensor. The device is based on the electro-oxidation of methanol to carbon dioxide on platinum catalyst into a polymeric-membrane fuel cell operated as a galvanic cell. The alcohol-water solution under examination is fed to the anode (positive side) of a polymeric membrane fuel cell, where it reacts with water to produce carbon dioxide, protons, and electrons. Protons diffuse through the electrolyte material and recombine with electrons on the cathode catalyst (negative side). At high potentials (>0.7V) mass transfer of methanol to the electrode solution interface controls the observed current. Therefore, it is possible to correlate the solution concentration to the observed limiting current. This method was successfully applied to relatively diluted solutions (concentration <1M). The application of this principle to more concentrate solutions (up to 2M) requires an optimization of the anode structure to enhance the influence of mass transport limitation. Moreover, during continuous operation of the sensor, a decay of the signal was observed: the absence of a steady-state current value hinders the application of the sensor. An explanation of this phenomenon and a possible solution strategy are proposed.
publisherThe American Society of Mechanical Engineers (ASME)
titleStudy of an Electrochemical Alcohol Concentration Sensor: Optimization of the Anode Structure
typeJournal Paper
journal volume4
journal issue3
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.2756558
journal fristpage345
journal lastpage349
identifier eissn2381-6910
keywordsAnodes
keywordsSensors
keywordsMethanol
keywordsoxidation
keywordsOptimization
keywordsElectrodes
keywordsSignals
keywordsEthanol AND Catalysts
treeJournal of Fuel Cell Science and Technology:;2007:;volume( 004 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record