Show simple item record

contributor authorT. Franco
contributor authorZ. HoshiarDin
contributor authorP. Szabo
contributor authorM. Lang
contributor authorG. Schiller
date accessioned2017-05-09T00:24:22Z
date available2017-05-09T00:24:22Z
date copyrightNovember, 2007
date issued2007
identifier issn2381-6872
identifier otherJFCSAU-28931#406_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/136085
description abstractIn the thin-film solid oxide fuel cell (SOFC) concept of the German Aerospace Center (DLR) in Stuttgart, the entire membrane electrode assembly (MEA) is deposited onto a porous metallic substrate by an integrated multistep vacuum plasma spray (VPS) process. This concept enables the production of very thin and stable electrodes and electrolyte layers with a total cell thickness of only 100–120μm. In this concept, the porous ferrite substrate material predominantly acts as mechanical cell support and as fuel gas distributor. In general, ferrite substrate alloys with high chromium and low manganese content show both excellent corrosion stability and adequate thermal expansion behavior. Nevertheless, at the high process temperature in the SOFC of ∼800°C, atomic transport processes can show a detrimental effect on cell performance, at least at the required long-term operation. Problems arise, in particular, through diffusion processes of Fe-, Cr-, and Ni-species between the Ni/8YSZ anode and the ferrite steel-based substrate material. This can induce significant structure changes both in the anode and the substrate. As a reliable solution of this key problem, a plasma sprayed thin diffusion barrier layer is seen at the interface between anode and substrate, which consists of an electrically conductive and chemically stable ceramic component. For this purpose, some doped perovskite-type LaCrO3, such as La1−xSrxCrO3−δ, La1−xCaxCrO3−δ, or La1−xSrxCr1−yCoyO3−δ were investigated and tested carefully at DLR. These types of perovskites show a high potential to fulfill all the required properties that are needed for the applicability as an anode-side diffusion barrier layer. The paper focuses on basic investigations of differently doped LaCrO3 compounds under SOFC-relevant conditions concerning thermal expansion, electrical conductivity, chemical stability, etc. Furthermore, first results of electrically and electrochemically characterized half cells carried out with some qualified doped LaCrO3 are shown. Finally, the diffusion barrier layer is demonstrated as a new SOFC component that is effective at cell operating conditions.
publisherThe American Society of Mechanical Engineers (ASME)
titlePlasma Sprayed Diffusion Barrier Layers Based on Doped Perovskite-Type LaCrO3 at Substrate-Anode Interface in Solid Oxide Fuel Cells
typeJournal Paper
journal volume4
journal issue4
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.2756846
journal fristpage406
journal lastpage412
identifier eissn2381-6910
keywordsElectrical conductivity
keywordsDiffusion (Physics)
keywordsAnodes
keywordsPlasmas (Ionized gases)
keywordsSolid oxide fuel cells
keywordsCathode ray oscilloscopes
keywordsThermal expansion
keywordsStability
keywordsElectrolytes AND Diffusion processes
treeJournal of Fuel Cell Science and Technology:;2007:;volume( 004 ):;issue: 004
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record