Show simple item record

contributor authorVincent A. C. Haanappel
contributor authorJosef Mertens
contributor authorAndreas Mai
date accessioned2017-05-09T00:20:30Z
date available2017-05-09T00:20:30Z
date copyrightAugust, 2006
date issued2006
identifier issn2381-6872
identifier otherJFCSAU-28926#263_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/134047
description abstractTargets in the development of anode-supported or planar solid oxide fuel cells (SOFCs) are low operation temperatures, high durability, high reliability, high power density, and low production costs. During the past ten years steps have already been taken at Forschungszentrum Jülich to lower the operating temperatures while maintaining the power output. This was achieved by optimizing processing and microstructural parameters of the electrodes. This paper presents the latest results concerning performance improvement through variations of the processing route and the microstructure of La0.65Sr0.3MnO3 (LSM) and La0.58Sr0.4Co0.2Fe0.8O3−δ (LSCF)-type SOFCs. In the case of the LSM-type single cells, the following aspects relating to the electrochemical performance were investigated in more detail: (1) production of the anode substrate by tape casting versus warm pressing; (2) deposition of the anode functional layer (AFL) and electrolyte by screen printing versus vacuum slip casting; (3) use of noncalcined and non-ground YSZ for applying the cathode functional layer (CFL); and (4) sintering temperature of the CFL and cathode current collector layer (CCCL). In the case of LSCF-type cells, a systematic approach was initiated for optimizing the Ce0.8Gd0.2O2−δ (CGO) diffusion barrier layer: (1) deposition techniques of the CGO layer and (2) sintering temperature of the screen-printed CGO layer. Results have shown that certain modifications of the processing route led to a slightly lower electrochemical performance, whereas others did not affect the performance at all. Regarding LSCF-type SOFCs, a slight improvement of the performance was achieved by optimizing the sintering temperature of the CGO layer.
publisherThe American Society of Mechanical Engineers (ASME)
titlePerformance Improvement of (La,Sr)MnO3 and (La,Sr)(Co,Fe)O3-Type Anode-Supported SOFCs
typeJournal Paper
journal volume3
journal issue3
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.2205359
journal fristpage263
journal lastpage270
identifier eissn2381-6910
keywordsTemperature
keywordsDiffusion (Physics)
keywordsElectric potential
keywordsAnodes
keywordsMeasurement
keywordsSintering
keywordsSolid oxide fuel cells
keywordsElectrolytes
keywordsPrinting
keywordsVacuum
keywordsSlip casting (Process) AND Current density
treeJournal of Fuel Cell Science and Technology:;2006:;volume( 003 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record