Show simple item record

contributor authorS. Frangini
contributor authorS. Loreti
contributor authorA. Masci
date accessioned2017-05-09T00:16:48Z
date available2017-05-09T00:16:48Z
date copyrightFebruary, 2005
date issued2005
identifier issn2381-6872
identifier otherJFCSAU-27240#60_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/132119
description abstractA new aluminization method for molten carbonate fuel cell bipolar plate wet seals is described in this paper based on the application of the electrospark deposition (ESD) process. The molten carbonate corrosion behavior of single Al, FeAl, and a dual (FeAl∕Al) diffusion coating applied onto a AISI 316L steel sheet of 0.5 mm thickness is examined. FeAl-containing coatings show low-rate corrosion after exposure to a (Li+K) carbonate melt at 650 °C for 1000 h, whereas the single Al coating suffers excessive corrosion. Coatings degradation modes involve interdiffusion phenomena and transient formation of nodule iron–oxides. The dual (FeAl∕Al) coating exhibits the best corrosion resistance due to its higher Al surface content. Characteristics of the ESD coatings in terms of thickness, uniformity, and composition are also reported.
publisherThe American Society of Mechanical Engineers (ASME)
titleDevelopment of a New Aluminizing Method for Molten Carbonate Fuel Cell Wet Seals
typeJournal Paper
journal volume2
journal issue1
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.1843119
journal fristpage60
journal lastpage64
identifier eissn2381-6910
keywordsDiffusion (Physics)
keywordsCoating processes
keywordsCoatings
keywordsCorrosion
keywordsCorrosion resistance
keywordsMolten carbonate fuel cells
keywordsIron
keywordsThickness AND Aluminum coatings
treeJournal of Fuel Cell Science and Technology:;2005:;volume( 002 ):;issue: 001
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record