Show simple item record

contributor authorH. Willems
contributor authorR. Sierens
date accessioned2017-05-09T00:10:11Z
date available2017-05-09T00:10:11Z
date copyrightApril, 2003
date issued2003
identifier issn1528-8919
identifier otherJETPEZ-26821#479_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/128383
description abstractThe initial size and growth of the plasma and flame kernel just after spark discharge in S.I. engines determines if the flame becomes self-sustainable or extinguishes. On the other hand, the development of the kernel during the initial phases has non-negligible influences on the further combustion. For example, cyclic variations often find their origin in the beginning of combustion and determine the working limits of the engine and the driving behavior of the vehicle. These factors demonstrate the crucial importance of the knowledge of the initial growth of the plasma and flame kernel in S.I. engines. A complete model is developed for the growth of the initial plasma and flame kernel in S.I. engines, which takes into account the fundamental properties of the ignition system (electrical energy and power, geometry of the spark plug, heat losses to the electrodes and the cylinder wall), the combustible mixture (pressure, temperature, equivalence ratio, fraction of residual gasses, kind of fuel), and the flow (average flow velocity, turbulence intensity, stretch, characteristic time and length scales). The proposed model distinguishes three phases: the pre-breakdown, the plasma, and the initial combustion phase. The model of the first two phases is proposed in a previous article of the same authors [1], the latter is exposed in this article. A thermodynamic model based on flamelet models and which takes stretch into account, is used to describe the initial combustion phase. The difference between heat losses to the electrodes and the cylinder wall is considered. The burning velocity varies from the order of the laminar velocity to the fully developed burning velocity. The evolution is determined as well by the life time as by the size of the kernel. The stretch (caused by turbulence and by the growth of the kernel), the nonadiabatic character of the flame, and instabilities have influence on the laminar burning velocity. Validation of this model is done using measurements of the expansion in a propane-air mixture executed by Pischinger [2] at M.I.T. The agreement seems very good.
publisherThe American Society of Mechanical Engineers (ASME)
titleModeling the Initial Growth of the Plasma and Flame Kernel in SI Engines
typeJournal Paper
journal volume125
journal issue2
journal titleJournal of Engineering for Gas Turbines and Power
identifier doi10.1115/1.1501912
journal fristpage479
journal lastpage484
identifier eissn0742-4795
keywordsCombustion
keywordsPlasmas (Ionized gases)
keywordsFlames
keywordsEngines
keywordsTemperature
keywordsFlow (Dynamics)
keywordsTurbulence AND Ignition
treeJournal of Engineering for Gas Turbines and Power:;2003:;volume( 125 ):;issue: 002
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record