| description abstract | The dynamic load head-disk contact induced impact stress was studied. A dual channel LDV was used to measure the head-disk relative motion during impact, and an analytical model incorporating the Hertz theory of impact was developed to quantitatively estimate the impact induced contact force and stress based on the LDV-measured results. 70 percent sliders were used in order to compare the results with our previous study. From the estimated maximum contact stresses and the results of our previous study, it was found that when the average maximum stress was 511 MPa, the head-disk interface did not show any damage after 100,000 cycles of repeated head-disk impacts. When the average maximum stress was 880 MPa, however, 100,000 repeated head-disk impacts caused significant wear of the disk’s overcoat even though a single impact did not cause any observable damage. From the analysis it can be seen that a lower head-disk impact velocity and/or a larger radius of curvature at the contacting corner of the slider result in a smaller head-disk impact stress on the disk. Based on the analyses, we estimated the radius of curvature needed for a 50 percent (Nano) slider and a 30 percent (Pico) slider to have at least 100,000 cycles of dynamic load head-disk interface durability. Such radius of curvature can be realized, for example, by edge-blending the sliders. [S0742-4787(00)02901-5] | |
