| contributor author | S. Chick | |
| contributor author | M. B. Mendel | |
| date accessioned | 2017-05-08T23:57:19Z | |
| date available | 2017-05-08T23:57:19Z | |
| date copyright | February, 1998 | |
| date issued | 1998 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27316#166_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/120815 | |
| description abstract | A recently-proposed probability model for cutting tool lifetimes based on tool wear curves is presented. Optimal tool replacement strategies and cutting conditions are calculated using this wear-based model. The model’s use of wear curves permits extrapolation of cost calculations to cutting conditions for which little statistical data has been collected, assuming data is available for other cutting conditions which have the same failure mechanism. This is particularly important during process design changes, when data is expensive to obtain or limited in quantity. Analysis indicates that an important factor in tool replacement is run-in wear. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Using Wear Curves to Predict the Cost of Changes in Cutting Conditions | |
| type | Journal Paper | |
| journal volume | 120 | |
| journal issue | 1 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.2830094 | |
| journal fristpage | 166 | |
| journal lastpage | 168 | |
| identifier eissn | 1528-8935 | |
| keywords | Wear | |
| keywords | Cutting | |
| keywords | Probability | |
| keywords | Process design | |
| keywords | Cutting tools AND Failure mechanisms | |
| tree | Journal of Manufacturing Science and Engineering:;1998:;volume( 120 ):;issue: 001 | |
| contenttype | Fulltext | |
