Show simple item record

contributor authorT. Hoshi
contributor authorK. Okushima
date accessioned2017-05-08T23:35:33Z
date available2017-05-08T23:35:33Z
date copyrightNovember, 1965
date issued1965
identifier issn1087-1357
identifier otherJMSEFK-27495#442_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/108556
description abstractSelection of cutter diameter and position of the cutter with reference to the work piece was studied to control the face-milling tool tip failure by fracture. The majority of the tests consisted of studies of the effect of angle of engagement and angle of disengagement on fractures at low and high cutting speeds. The result shows that the angle of disengagement is more critical than the angle of engagement. Favorable cutter diameters and positions based on empirical data are recommended to prevent fractures occurring at low and high cutting speeds. This report suggests that steel can be face-milled with titanium carbide and aluminum oxide tools using optimum setups as suggested by this study.
publisherThe American Society of Mechanical Engineers (ASME)
titleOptimum Diameter and Position of a Fly Cutter for Milling 0.45 C Steel, 195 BhN and 0.4 C Steel, 167 BhN at Light Cuts
typeJournal Paper
journal volume87
journal issue4
journal titleJournal of Manufacturing Science and Engineering
identifier doi10.1115/1.3670858
journal fristpage442
journal lastpage446
identifier eissn1528-8935
keywordsSteel
keywordsMilling
keywordsFracture (Process)
keywordsCutting
keywordsFailure
keywordsEquipment and tools
keywordsTitanium AND Aluminum
treeJournal of Manufacturing Science and Engineering:;1965:;volume( 087 ):;issue: 004
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record