Search
CSV
RISGeneric Simulation Approach for Multi-Axis Machining, Part 2: Model Calibration and Feed Rate Scheduling
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This is the second part of a two-part paper presenting a new methodology for analytically simulating multi-axis machining of complex sculptured surfaces. The first section of this paper offers ...
Generic Simulation Approach for Multi-Axis Machining, Part 1: Modeling Methodology
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a new methodology for analytically simulating multi-axis machining of complex sculptured surfaces. A generalized approach is developed for representing an arbitrary cutting edge ...
Surface Integrity of Die Material in High Speed Hard Machining, Part 1: Micrographical Analysis
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The effects of cutting conditions and tool wear on chip morphology and surface integrity during high speed machining of D2 tool steel (60–62 Hrc) are investigated experimentally and analytically ...
Surface Integrity of Die Material in High Speed Hard Machining, Part 2: Microhardness Variations and Residual Stresses
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The main objective of this paper is to investigate the quality and integrity of the surface produced during high speed hard machining (HSHM) of D2 tool steel in its hardened state (60–62 ...