Search
CSV
RISPredicting the Fracture Initiation Transition Temperature in High Toughness, Low Transition Temperature Line Pipe With the COD Test
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes the use of the crack opening displacement (COD) test to predict the fracture initiation transition temperature of high toughness, low-transition temperature in line pipe. A ...
Discussion: “Ideal Spiral Bevel Gears—A New Approach to Surface Geometry” (Huston, R. L., and Coy, J. J., 1981, ASME J. Mech. Des., 103, pp. 127–132)
Publisher: The American Society of Mechanical Engineers (ASME)
The Fluctuating Flow of a Gas Near a Stagnation Point on a Hot Wall
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Solutions are given in series, valid for low and high frequencies, for the two-dimensional flow in the vicinity of a stagnation point due to an incident stream, assumed incompressible, which ...
Discussion: “Dual Clearance Squeeze Film Damper for High Load Conditions” (Fleming, David P., 1985, ASME J. Tribol., 107, pp. 274–278)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “A Format Method for Generating Liapunov Functions” (Peczkowski, J. L., and Liu, R. W., 1967, ASME J. Basic Eng., 89, pp. 433–439)
Publisher: The American Society of Mechanical Engineers (ASME)
The Problems of Sealing Hydrogen Peroxide in a 3000-F Environment
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: With the advent of advanced flight vehicles powered by ramjet power plants, fuel accessory equipment, such as turbopumps, will be subjected to severe environments of: (1) High temperatures (from ...
Minimum Load Requirements for the Prevention of Skidding in High Speed Thrust Loaded Ball Bearings
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes the development of an empirical equation used to determine the minimum thrust load that is required to prevent gross ball and cage skidding in high speed angular contact ...
On the Kinematics of the Closed Epicyclic Differential Gears
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The epicyclic differential gear has been known in modern times since 1575 when it appeared as a mechanism in a clock. Artifacts from an ancient shipwreck prove that it was known to the ...
Discussion: “Surface Geometry of Circular Cut Spiral Bevel Gears” (Huston, R. L., and Coy, J. J., 1982, ASME J. Mech. Des., 104, pp. 743–748)
Publisher: The American Society of Mechanical Engineers (ASME)
Weight Optimization of Stiffened Cylindrical Panels
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Many structures have curved panels with longitudinal, transverse, or orthogonal tee-stiffeners subjected to differential pressure, band loading, and axial and circumferential in-plane forces. Equations ...