Search
Now showing items 1-10 of 31
Curvatures and Sliding Ratios of Conjugate Surfaces
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A new approach for curvatures of conjugate surfaces is provided in this paper. The main characteristic of the approach is that relative curvatures and geodesic torsions of the conjugate surfaces ...
Erratum: “Discussion of ‘Experimental Measurement in a Centrifugal Pump Impeller,’” [ASME J. Fluids Eng., 1997, 119(3), p. 729]
Publisher: The American Society of Mechanical Engineers (ASME)
Instability of Oil Bearings Due to High Oil Viscosity
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: On a large turboblower running in oil bearings, it was found that the rotor became seriously unstable when the bearing oil temperature was low. It will be shown that this unstable vibration ...
Discussion: “Off-Design Flow Measurements in a Centrifugal Compressor Vaneless Diffuser” (Pinarbasi, A., and Johnson, M. W., 1995, ASME J. Turbomach., 117, pp. 602–608)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Pressure Fluctuation on Casing Wall of Isolated Axial Compressor Rotors at Low Flow Rate” (Inoue, M., Kuroumaru, M., and Ando, Y., 1993, ASME J. Turbomach., 115, pp. 19–26)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “An Experimental Investigation of Stator Induced Unsteadiness on Centrifugal Impeller Outflow” (Ubaldi, M., Zunino, P., Barigozzi, G., and Cattanei, A., 1996, ASME J. Turbomach., 118, pp. 41–51)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “A Note on the Phase Relationships Involved in the Whirling Instability in Tube Arrays” (Savkar, S. D., 1977, ASME J. Fluids Eng., 99, pp. 727–730)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Experimental Measurements in a Centrifugal Pump Impeller” (Bwalya, A. C., and Johnson, M. W., 1996, ASME J. Fluids Eng., 118, pp. 692–697)
Publisher: The American Society of Mechanical Engineers (ASME)
Flow-Induced Vibration and Noise in Tube-Bank Heat Exchangers Due to von Karman Streets
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper treats the problem of vibration and noise in tube-bank heat exchangers. The frequency of vortex shedding has been investigated by many authors, and their results have varied considerably. ...
Karman Vortex Streets and Flow-Induced Vibrations in Tube Banks
Publisher: The American Society of Mechanical Engineers (ASME)
CSV
RIS