Search
CSV
RISDiscussion: “Optimum Diameter and Position of a Fly Cutter for Milling 0.45 C Steel, 195 BhN and 0.4 C Steel, 167 BhN at Light Cuts” (Hoshi, T., and Okushima, K., 1965, ASME J. Eng. Ind., 87, pp. 442–446)
Publisher: The American Society of Mechanical Engineers (ASME)
Computerized Determination and Analysis of Cost and Production Rates for Machining Operations. Part 1—Turning
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Two of the most important factors in any machining operation are the cost per piece and the production rate. Equations have been developed which enable one to calculate these two factors for ...
Computerized Determination and Analysis of Cost and Production Rates for Machining Operations: Part 2—Milling, Drilling, Reaming, and Tapping
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In Part 1 of this two-part paper, generalized equations for cost and production were presented for five major types of machining operations: turning, milling, drilling, reaming, and tapping. In ...
Geospatial DSS for Maintaining Agricultural Diversions under Environmental Flow Requirements
Publisher: ASCE
Abstract: Competing demands for scarce water supplies in irrigated alluvial valleys can lead to conflicts between disparate uses, resulting in an increased risk of restrictions on agricultural diversions. A tool for understanding ...