Search
CSV
RISSolar Tests of Aperture Plate Materials for Solar Thermal Dish Collectors
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In parabolic dish solar collectors, walk-off of the spot of concentrated sunlight can be a hazard if a malfunction causes the concentrator to stop following the sun. A test program, therefore, ...
Discussion: “The Wear Coefficient—Magnitude, Scatter, Uses” (Rabinowicz, E., 1981, ASME J. Lubr. Technol., 103, pp. 188–193)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “A Note on Blade Loss Dynamics of Rotor-Bearing Systems” (Kirk, R. G., and Hibner, D. H., 1976, ASME J. Eng. Ind., 98, pp. 497–503)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Measurement of Oil Film Thickness for Application to Elastomeric Stirling Engine Rod Seals” (Krauter, A. I., 1982, ASME J. Lubr. Technol., 104, pp. 455–459)
Publisher: The American Society of Mechanical Engineers (ASME)
Strength Coefficients of the Cubic Criterion for Graphite Composites
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Marine Pipeline Analysis Based on Newton’s Method With an Arctic Application” (Dareing, D. W., and Neathery, R. F., 1970, ASME J. Eng. Ind., 92, pp. 827–833)
Publisher: The American Society of Mechanical Engineers (ASME)
Partial Stochastic Linearization of a Spherical Pendulum With Coriolis Damping Produced by Radial Spring and Damper
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This study considers the stochastic analysis of a spherical pendulum, whose bidirectional vibration is reduced by spring and damper installed in the radial direction between the point mass and the cable. Under sway motion, ...
Discussion: “Nondimensional Presentation of Frictional Tractions in Elastohydrodynamic Lubrication—Part II: Starved Conditions” (Archard, J. F., and Baglin, K. P., 1975, ASME J. Lubr. Technol., 97, pp. 412–421)
Publisher: The American Society of Mechanical Engineers (ASME)
Traction and Film Thickness Measurements Under Starved Elastohydrodynamic Conditions
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Traction measurements under starved elastohydrodynamic conditions have been obtained for a point contact geometry. Simultaneous measurements of the film thickness and the location of the inlet ...
Discussion: “An Experimental Evaluation of the Hamrock and Dowson Minimum Film Thickness Equation for Fully Flooded EHD Point Contacts” (Koye, K. A., and Winer, W. O., 1981, ASME J. Lubr. Technol., 103, pp. 284–294)
Publisher: The American Society of Mechanical Engineers (ASME)