Search
CSV
RISAnalysis of the High Performance Drilling Process: Influence of Shape and Profile of the Cutting Edge of Twist Drills
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The aims of the investigations presented in this paper were to measure the tool load under conditions of high performance drilling and to analyze if changes of the tool edge shape as well ...
Limb Correction Effects on TIROS-N Microwave Sounding Unit Observations
Publisher: American Meteorological Society
Abstract: Evaluations of limb-corrected brightness temperatures computed by NESDIS from TIROS-N MSU observed brightness temperatures are presented. Observed brightness temperatures both before and after limb correction are compared ...
A Two‐Week Evaluation of Available Potential Energy and Kinetic Energy from NMC and ECMWF Analyses
Publisher: American Meteorological Society
Abstract: Available potential energy and kinetic energy distributions for the Northern Hemisphere computed from the FGGE Level IIIa analyses produced at the National Meteorological Center (NMC) and the Level IIIb analyses prepared ...
Motivation for and Development of a Standardized Introductory Meteorology Assessment Exam
Publisher: American Meteorological Society
Abstract: ducation research has shown that there is often a disconnect between what instructors teach and what students actually comprehend. Much of this disconnect stems from students? previous conceptions of the subject that often ...
The Use of Available Potential Energy to Evaluate the Impact of Satellite Data on Numerical Model Analysis during FGGE
Publisher: American Meteorological Society
Abstract: Available potential energy (APE) calculations are used to evaluate the influence of the FGGE satellite observing system during the first Special Observing Period (SOP-1). Two datasets consisting of the Goddard Laboratory ...
New Testing Approach for Extracting the Shear Friction Material Properties of Ultra-High-Performance Fiber-Reinforced Concrete
Publisher: American Society of Civil Engineers
Abstract: Shear friction (SF) theory governs the relationship between the stresses and displacements that occur due to sliding along a concrete-to-concrete interface subjected to varying degrees of lateral confinement. This theory ...
Esophageal Prosthesis For Refractory Gastresophageal Reflux Disease Prevention
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: 5.7 million Americans are clinically diagnosed each year with refractory gastresophageal reflux disease (GERD), characterized by chronic stomach acid reflux that is insensitive to both lifestyle ...
Establishing the Feasibility of a Sensor Based Sock Management System1
Publisher: The American Society of Mechanical Engineers (ASME)
A Validated Numerical Experimental Design Methodology for a Movable Supersonic Ejector Compressor for Waste Heat Recovery
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The aim of this paper is to develop the technical knowledge, especially the optimum geometries, for the design and manufacturing of a supersonic gas–gas ejector for a wasteheat driven vehicle cooling system. Although ...
The Development of a Fine- and Microstructure Profiler
Publisher: American Meteorological Society
Abstract: A new freely-falling ocean profiler for measuring finescale variations in temperature, salinity and horizontal velocity and microscale variations in temperature, conductivity, velocity and refractive index has been ...