Search
CSV
RISThermodynamic Analysis and Comparison on Oxy-Fuel Power Generation Process
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In this paper, pressurized oxy-fuel combustion power generation processes are modeled and analyzed based on a 350 MW subcritical reheat boiler associated with a condensing steam turbine. The ...
Cascade Utilization of Fuel Gas Energy in Gas to Liquids Plant
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper investigates on a gastoliquids (GTL) plant with ATR syngas production and proposes a new process to use a gas turbine and waste heat recovery gas/steam streams preheater to replace the fired heater. The new ...
Advanced Combined Cycle Systems Based on Methanol Indirect Combustion
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In this paper, two new combined cycle systems with/without CO2 capture based on methanol indirect combustion are developed, which have significantly higher efficiency than methanol fueled conventional ...
The Application of Actuator Disks to Calculations of the Flow in Turbofan Installations
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper discusses the application of an actuator disk model to the problem of calculating the asymmetric performance of a turbofan operating behind a nonaxisymmetric intake and due to the ...
The Simulation of Turbomachinery Blade Rows in Asymmetric Flow Using Actuator Disks
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes the development of actuator disk models to simulate the asymmetric flow through high-speed low hub-to-tip ratio blade rows. The actuator disks represent boundaries between ...
A Method for Assessing Effects of Circumferential Flow Distortion on Compressor Stability
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes the development of a new analysis to predict the onset of flow instability for an axial compressor operating in a circumferentially distorted inlet flow. A relatively simple ...
Stability of Flow Through Multistage Axial Compressors
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes measurements of the performance of a research stage operating in isolation and as part of a multistage compressor. It is shown that the stall point and the stalled ...
The Investigation of Turbine and Exhaust Interactions in Asymmetric Flows— Blade-Row Models Applied
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes the blade-row models applied to the asymmetric flow-field coupling between turbine and exhaust system. Numerical actuator disk is applied to represent a turbine blade row ...
Extending the Period of Data Retrieval for Vertical Inclinometers
Publisher: American Society of Civil Engineers
Abstract: Vertical inclinometers are effective tools for accurately measuring horizontal deformations in soil and identifying the location of sliding surfaces. One drawback of inclinometers is that they can tolerate only limited ...
Hybrid Power Generation Plant for CO2 Capture
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In this paper, the issues and challenges of capturing CO2 from a pulverized coal (PC) power plant have been summarized and assessed and a hybrid power generation configuration is developed, which features a gasturbine ...