Search
CSV
RISApplicability of Controlled Low-Strength Materials with Incinerated Sewage Sludge Ash and Crushed-Stone Powder
Publisher: American Society of Civil Engineers
Abstract: This paper discusses the applicability of new controlled low-strength materials (CLSM) that include incinerated sewage sludge ash. The incinerated sewage sludge ash was used as a replacement for fly ash, which is the main ...
Response of Backflow to Flow Rate Fluctuations
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The response of backflow at the inlet of an inducer to the flow rate fluctuation is studied by using three-dimensional numerical calculations based on the k-ϵ turbulence model for the discussion ...
Quasi-Three-Dimensional Analysis of Cavitation in an Inducer
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A method for the prediction of steady cavitation in turbopumps is proposed on the assumption that the fluid is inviscid and the stream surface is rotationally symmetric. The analysis in the ...
Theoretical and Experimental Evaluation of Double-Notch Shear Strength of G-10CR Glass-Cloth/Epoxy Laminates at Cryogenic Temperatures
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The cryogenic interlaminar shear behavior of G-10CR glass-cloth/epoxy laminates has been discussed through theoretical and experimental characterizations. The use of the double-notch shear test for ...
Double Cantilever Beam Measurement and Finite Element Analysis of Cryogenic Mode I Interlaminar Fracture Toughness of Glass-Cloth/Epoxy Laminates
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: An experimental and analytical investigation in cryogenic Mode I interlaminar fracture behavior and toughness of SL-E woven glass-epoxy laminates was conducted. Double cantilever beam (DCB) tests ...
Analytical and Experimental Studies of Short-Beam Interlaminar Shear Strength of G-10CR Glass-Cloth/Epoxy Laminates at Cryogenic Temperatures
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Cryogenic interlaminar beam tests in the form of three-point flexure are examined both experimentally and analytically. The use of the short-beam shear test for measuring the interlaminar shear ...
Cryogenic Fracture Toughness Determination of a Structural Alloy Weldment by Notch Tensile Measurement and Finite Element Analysis
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper investigates the use of circumferentially notched bar specimens for the measurement of elastic-plastic fracture toughness (JIC) of structural alloys and weldments for superconducting ...
Analysis and Testing of Mixed-Mode Interlaminar Fracture Behavior of Glass-Cloth∕Epoxy Laminates at Cryogenic Temperatures
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents results from an analytical and experimental study of the effect of temperature and mixed-mode ratio on the interlaminar fracture toughness in glass-cloth∕epoxy laminates. Mode ...
Analysis and Testing of Indentation Fracture Behavior of Piezoelectric Ceramics Under an Electric Field
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: To estimate the electric fracture toughness, indentation fracture (IF) tests were made on piezoelectric materials under combined mechanical and electrical loads. Lead zirconate titanate (PZT) ...
Linear Stability Analysis of the Effects of Camber and Blade Thickness on Cavitation Instabilities in Inducers
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: It has been shown by experimental and numerical studies that various cavitation instabilities occur in inducers for rocket engines when the cavity length exceeds about 65% of the blade spacing. ...