Search
Now showing items 1-8 of 8
Some Characteristics of High Waves in Closed Channels Approaching Kelvin-Helmholtz Instability
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The characteristics of water waves produced by flowing air in closed channels were studied to uncover the effects of surface pressure variation. From theoretical considerations, it is proposed ...
The Effect of Waves on the Oil Slick at a Retention Boom
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In the previous paper on this subject it was found that the oil-water interface at the retention boom becomes unstable under certain conditions permitting an oil escape under the boom. In the ...
Interfacial Shear in Two-Phase Wavy Flow in Closed Horizontal Channels
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The interfacial shear stress for air flowing over a wavy water surface was determined experimentally in a closed horizontal channel by measuring the pressure drop and the structure of the water ...
A Method for Measuring Aerodynamic Pressure Below Wave Crests
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes a submersible pressure probe, which permits the measurement of the pressure near the surface of a water wave, even in the regions below the crest. The probe is based on ...
The Behavior of the Oil-Water Interface at a Planar Boom
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: It has been observed that, under certain conditions, the oil retained by planar boom will escape under it. In this work it is proposed that this escape is due to the instability of the ...
Oil Thickness Variation on Wavy Water in the Presence of Wind
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The effect of the wind on the distribution of an oil layer on wavy water has been examined analytically and the results are compared with experimental values. It is found that the wind tends ...
Discussion: “On the Flow Fields of Inertial Impactors” (Marple, V. A., Liu, B. Y. H., and Whitley, K. T., 1974, ASME J. Fluids Eng., 96, pp. 394–400)
Publisher: The American Society of Mechanical Engineers (ASME)
Horizontal Slug Flow: A Comparison of Existing Theories
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Over the last twenty years a number of papers have appeared in literature concerning the transition to slug flow in horizontal two-phase flow. The theories proposed in these papers are described, ...
CSV
RIS