Search
CSV
RISA Possible Mechanism for Causing Eccentricity in Sleeved Backup Rolls on Cold-Rolling Mills
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A theoretical analysis has shown that axial slipping of the sleeve on the roll arbor rather than plastic deformation of the roll necks may be the cause of backup-roll eccentricity on cold-rolling ...
Stability and Vibration of Transversely Isotropic Beams Under Initial Stress
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Stability of Squeeze Film Damped Multi-Mass Flexible Rotor Bearing Systems” (McLean, L. J., and Hahn, E. J., 1985, ASME J. Tribol., 107, pp. 402–409)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Mechanical Couplings—A Geometrical Theory” (Fichter, E. F., and Hunt, K. H., 1977, ASME J. Eng. Ind., 99, pp. 77–87)
Publisher: The American Society of Mechanical Engineers (ASME)
Recent Developments in Multiple Input Modal Analysis
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Over the last two decades in experimental modal analysis many different approaches have been developed for application to a great variety of structural engineering problems. The effectiveness of ...
Discussion: “Flexible Membrane Hydrostatic Air Bearing” (Levy, S. B., and Coogan, Jr., C. H., 1968, ASME J. Lubr. Technol., 90, pp. 184–190)
Publisher: The American Society of Mechanical Engineers (ASME)
The Stability of a Second Order Linear Periodic System
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Necessary and sufficient conditions are obtained for the stability of the following second order linear system: ẋ = θ(t)x, θ(t) = θt+i=1lTi and θ(t) = A1, 0<t<T1 = A2, T1<t<T1+T2 ...
Discussion: “Squeeze Film Bearing for the Elimination of Oil Whip” (Sweet, Joel, and Genin, Joseph, 1971, ASME J. Lubr. Technol., 93, pp. 252–257)
Publisher: The American Society of Mechanical Engineers (ASME)
An Analysis of Factors Used for Strength Rating Helical Gears
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper discusses the factors used to rate the strength of helical-gear teeth by means of the fundamental tooth-strength formula developed by the American Gear Manufacturers Association’s Gear ...
Influence of Flexibly Mounted Rolling Element Bearings on Rotor Response: Part I—Linear Analysis
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The paper evaluates the influence of damped, linear flexibly mounted rolling-element bearings on dynamic rotor unbalance response. The system analyzed is treated as a general four degree of ...