Search
CSV
RISEffect of TiO2–SiC and Heat Treatment on Tribological Characteristics of Bimodal Hybrid Aluminum Composites Under Dry Sliding Condition
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The dry sliding wear behavior of bimodal TiO2np/SiCp/Al6082 composites was studied using a pin-on-disk tribometer. The investigation included both as-cast alloy and T6 heat-treated composites, with variations in applied ...
Application of Fuzzy Set Theory in the Scheduling of a Tandem Cold-Rolling Mill
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In a tandem cold-rolling mill, a strip is successively reduced in gauge at each stand as it passes through the mill. The optimal scheduling of a tandem mill is an important but difficult ...
A Procedure for the Development of Control-Oriented Linear Models for Horizontal-Axis Large Wind Turbines
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In this work we describe a methodology to construct control-oriented, multi-input, multi-output linear models representing the dynamics of variable-speed, pitch-controlled horizontal-axis wind turbines ...
Damage Localization by Isolating the Part of the Response Due to the Damage Only
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A new physical parameter is presented and it is applied to damage detection to address the two main challenges in the field of vibrationbased structural health monitoring: the sensitivity of detection and the requirement ...
Modeling Origin-Destination Effects on Roundabout Operations and Inflow Control
Publisher: American Society of Civil Engineers
Abstract: Traffic flows around roundabouts have been found to be dependent on origin-destination flows, but the true nature of this relationship is not properly understood. Present analyses are based on either gap acceptance models ...
Geometric Mean of Fin Efficiency and Effectiveness: A Parameter to Determine Optimum Length of Open-Cell Metal Foam Used as Extended Heat Transfer Surface
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: High porosity open-cell metal foams have captured the interest of thermal industry due to their high surface area density, low weight, and ability to create tortuous mixing of fluid. In this work, application of metal foams ...
Biodegradation of Environmentally Hazardous Azo Dyes and Aromatic Amines Using Klebsiella pneumoniae
Publisher: American Society of Civil Engineers
Abstract: A facultative bacterium was isolated from the sludge of a local dyeing industry for bioremediation of wastewater containing azo dyes. The identified Klebsiella pneumoniae by 16S ribosomal DNA (rDNA) sequence analysis was ...
Development and Calibration of a Simplified Nonlinear Spring Model for Predicting the Lateral Response of Caisson Foundations Using a Multiobjective Genetic Algorithm
Publisher: American Society of Civil Engineers
Abstract: Abstract This study introduces a simplified one-dimensional nonlinear spring model to predict
the lateral behavior of caisson foundations under combined lateral and moment loading
considering nonlinearities at both the ...
Tribological Behavior of Aluminum Matrix Composites Reinforced With Silicon-Based Refractory Compounds Derived From Rice Husk
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Abstract. Agricultural waste-derived metal matrix composites (MMCs) provide sustainable and cost-effective alternatives to conventional ceramic-reinforced materials. This work provides a systematic assessment of the solid ...
Identifying Bounds of Inorganic Content in Solventless Processing of Hybrid Solid Electrolytes
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Abstract. Solid-state lithium batteries require safe, robust electrolytes to enable higher energy densities and improved safety over conventional cells. Hybrid polymer–ceramic electrolytes are a promising solution, combining ...