Search
CSV
RISDiscussion: “Predicting the Shear Plane Angle in Machining From Work Material Strain-Hardening Characteristics” (Wright, P. K., 1982, ASME J. Eng. Ind., 104, pp. 285–293)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion of “<i>Hydraulic Conductivity of Two Prototype Clay Liners</i>” by Steven R. Day and David E. Daniel (August, 1985, Vol. 111, No. 8)
Publisher: American Society of Civil Engineers
Flow Past a Sphere With Surface Blowing and Suction
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The effect of uniform surface blowing and suction on the wake dynamics and the drag and lift forces on a sphere is studied using a high-resolution direct numerical simulation technique. The ...
Design of Natural Attenuation Landfills
Publisher: American Society of Civil Engineers
Abstract: The design of natural attenuation type sanitary landfills receiving municipal refuse is controlled by some key parameters in leachate. The attenuation mechanism(s) of the key parameters in the leachate are included. Equation ...
Discussion of “<i>Overburden Pressures Exerted on Clay Liners</i>” by Jeffrey J. Peirce, Goran Sallfors, and Louis Murray (April, 1986, Vol. 112, No. 2)
Publisher: American Society of Civil Engineers
Closure to “<i>Design of Natural Attenuation Landfills</i>” by Amalendu Bagchi (August, 1983)
Publisher: American Society of Civil Engineers
Finite Element Simulation of Chip Formation and Comparison with Machining Experiment
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a finite element model of orthogonal machining by using a 2-node link element to simulate chip separation. The chip and workpiece are connected by these link elements along ...
Managing Highway Bridges against Climate-Triggered Extreme Loading in Cold Regions
Publisher: American Society of Civil Engineers
Discussion of “<i>Mass Burning of MSW with Energy Recovery</i>” by Arthur H. Beckman and Mark G. Dragovich (June, 1986, Vol. 112, No. 3)
Publisher: American Society of Civil Engineers
Characterization of MSW Incinerator Ash
Publisher: American Society of Civil Engineers
Abstract: Incinerator ash produced due to mass burning of MSW may have significantly high concentration of water leachable constituents and may be classified as hazardous. A detailed waste characterization program undertaken for a ...