Abstract: A new regulating wheel truing method for through-feed centerless grinding is presented. In conventional regulating wheel truing systems, a single-point diamond tool is traversed across the regulating ...

Abstract: A new frontier of manufacturing research, biomedical manufacturing, is presented. Advanced manufacturing technologies, such as manufacturing processes, systems, and quality control, can be readily ...

Abstract: The American Society of Civil Engineers emphasizes that its strength is founded on member involvement at the local level. To foster an information exchange, the Society provides an opportunity at National Conventions for ...

Abstract: Three ocean-atmosphere models are constructed and evaluated for further studies of climatic variability and climatic sensitivity. All the models are based on the two-layer, highly truncated spectral atmospheric model of ...

Abstract: No Abstract Available.

Abstract: For a given level of irrigation uniformity there is a trade‐off between the amount of water applied and the area that receives some target amount of water. If the distribution of infiltrated depth is known (e.g., a normal ...

Abstract: Providing water to users on demand usually requires an increase in canal capacity over the same volume of water delivered at a uniform rate. A simulation model was used to develop demand patterns for hypothetical surface ...

Abstract: This paper presents a method for describing and evaluating some of the major factors that cause nonuniformity in surface irrigation systems. Methods including the following are presented for statistically combining these ...

Abstract: A modification to the double‐sweep routine commonly used to solve the continuity and momentum equations for surface irrigation models has been developed to allow the solution of one global parameter at each time step. ...