Search
CSV
RISDiscussion: “Bending Titanium and Beryllium Sheet in Pressurized Fluid” (Meyer, G. E., and Fiorentino, R. J., 1972, ASME J. Basic Eng., 94, pp. 589–594)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Forming of 7075-T6 Aluminum in High Pressure Environments” (Pendleton, R. L., and Davis, R. L., 1972, ASME J. Basic Eng., 94, pp. 595–598)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Effects of Cold Working Under Pressure on Subsequent Yield” (Hoeg, J. G., and Davis, R. L., 1972, ASME J. Basic Eng., 94, pp. 575–580)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “A Viscometer for High-Pressure Use, and Some Results” (Winer, W. O., 1972, ASME J. Basic Eng., 94, pp. 586–588)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Pressure-Induced Ductility” (Avitzur, Boaz, and Avitzur, Betzalel, 1970, ASME J. Eng. Ind., 92, pp. 419–426)
Publisher: The American Society of Mechanical Engineers (ASME)
Punching of Copper Under Pressure
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Punching of copper sheet at atmospheric pressure and under environmental pressures up to about 160,000 psi showed the following: The fraction of slug thickness that is burnished is essentially ...
A Flexible Hydrostatic Extrusion Machine
Publisher: The American Society of Mechanical Engineers (ASME)